Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Red light doesn't flash after received the call or vm

Hi

The red light doesn't flash on our 7941 and 7961 after a missing call come or leave a voice message. Does anyone could show me how to troubleshoot or should I configure anything on CUCM and Unity?

CUCM version: 4.1

IP phone firmware: SCCP41.8-3-3S

Thanks. Leo

2 ACCEPTED SOLUTIONS

Accepted Solutions
Silver

Re: Red light doesn't flash after received the call or vm

Hi,

I've attached a troubleshooting guide for MWI problems. Make sure the on/off triggers are set in CCM and the ports are configured properly in Unity.

Solutions for Cisco Unity Message Waiting Indicator Problems:

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_tech_note09186a0080711ae3.shtml

Cisco Unity Troubleshooting Guide - Message Warning Indicators (MWI's):

http://www.cisco.com/en/US/docs/voice_ip_comm/unity/405/troubleshooting/guide/ex/tsg_0500.html

Does it work for all the other phone models?

Please rate useful posts...

New Member

Re: Red light doesn't flash after received the call or vm

It could be a restriction problem ! Be shure you have the MWI Ports in the right Partition/CSS

5 REPLIES
Silver

Re: Red light doesn't flash after received the call or vm

Hi,

I've attached a troubleshooting guide for MWI problems. Make sure the on/off triggers are set in CCM and the ports are configured properly in Unity.

Solutions for Cisco Unity Message Waiting Indicator Problems:

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_tech_note09186a0080711ae3.shtml

Cisco Unity Troubleshooting Guide - Message Warning Indicators (MWI's):

http://www.cisco.com/en/US/docs/voice_ip_comm/unity/405/troubleshooting/guide/ex/tsg_0500.html

Does it work for all the other phone models?

Please rate useful posts...

New Member

Re: Red light doesn't flash after received the call or vm

It could be a restriction problem ! Be shure you have the MWI Ports in the right Partition/CSS

New Member

Re: Red light doesn't flash after received the call or vm

Thanks. I change the CSS configuration and now the red lamp will turn on when receiving message. But can the red lamp will be turn on as well when there is a miss call?

Leo

New Member

Re: Red light doesn't flash after received the call or vm

No, the MWI will be triggered by the uniy or unity connection ! patrick

New Member

Re: Red light doesn't flash after received the call or vm

Understand, thanks.

Leo

416
Views
0
Helpful
5
Replies
CreatePlease login to create content