Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Redial fails if number has "end of dialing" #

Have upgraded to 3.1.3.a.

This may have happened before and we didn't notice it.

You successfully dial a number, 918001231234#, and the call goes through just fine. If you use the redial softkey later, the screen stays blank and the phone returns re-order tone.

Redial works if there is no #.

  • Other Collaboration Voice and Video Subjects
2 REPLIES
Cisco Employee

Re: Redial fails if number has "end of dialing" #

I have seen this problem with international calls. I have never used the # for end of dialing for US calls since the callmanager should route the call when it gets 1+(10 digits). I suspect that when you are dialing it by hand the # is disregarded since callmanager would already have enough digits to route the call. When you are doing the redial it is sending all the digits at once. I tried this on 3.2(1) and it did not even put the # in the dial string so the redial works everytime.

Hope this helps,

-Mckee

Cisco Employee

Re: Redial fails if number has "end of dialing" #

This seems to be specific to 3.1(3a), check out CSCdw79887.

239
Views
0
Helpful
2
Replies