We are running ICM version 4.0. We can only get a 30 second refresh rate on our MAWs. Does anyone know of a way to get a 10 second refresh rate, or if there is something in newer versions that addresses this?
The instructions below are for for 4.1, but I believe it is the same for 4.0. Its worth a try anyway.
Open regedt32 in the Run Command. From HKEY_LOCAL_MACHINE, click on SOFTWARE>GeoTel>ICR>(Instance Name - normally below "Active instance")>AW>ICR Montor.
On the right side of the screen when ICR Monitor is highlighted, you should see "RefreshRate: REG_SZ: 30" meaning the refresh is set at 30 seconds. To change, highlight this line, click on Edit on the menu bar and select "String". Change the number to 10 and click OK. The refresh will now cycle at 10 seconds. You need to make this change for each Monitor AW.
I have a screen print of the steps above should you need them.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.