Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

release complete or not release complete over h225

we have two Siemens PBX connected via two C7206+VXC Modules over QSIG.

the problem is now that if the PBX 1 send a Disconnect with

Apr 19 01:01:47.566: ISDN Se3/0:15: RX <- DISCONNECT pd = 8 callref = 0xD8ED

Apr 19 01:01:47.566: Cause i = 0x809F - Normal, unspecified

the router do not send a release complete over h225 to the other Router.

the same router send a release complete over h225 if

Apr 19 01:02:02.406: ISDN Se1/0:15: RX <- DISCONNECT pd = 8 callref = 0x0031

Apr 19 01:02:02.406: Cause i = 0x8090 - Normal call clearing

received from the same PBX

is this normal and if why, and if no what can i do that ist works ?

1 REPLY
Silver

Re: release complete or not release complete over h225

Try resetting the serial interface by shut and no shut. Or reload could release some of these states. This could solve the issue.

253
Views
0
Helpful
1
Replies
CreatePlease to create content