Every once in a while the phones at a remote site lose their caller ID. This is a site across a gig ethernet fiber link. It happens to 7960s, 40s and 10s. Rebooting the phone will allow the caller ID to come through. Or, if you wait a few days, it will suddenly start working again. It is CM 3.3.2 spC, 1 pub, 2 subs. The gateway at the site is a 7206 running 12.2.2T code. "From private" is displayed on the phone when a call comes in. Sometimes, after a few seconds of "from private," the number will finally display. Anyone have any ideas? Could this be bug CSCea78886? Why would it only affect 1 remote site?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...