Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Replaced 2811 voice gateway keeps downloading .cnf.xml file.

Cisco recommended that we replace Cisco 2811 with 12.3(11)T5 ipvoice because it was rebooting intermitently. On the new router I put 12.4(6)T ipvoice. The router came up fine but on the console I kept getting the following messages over and over again:

Loading HWT-POR-VR1.cnf.xml from 192.168.1.5 (via FastEthernet0/0): !

[OK - 22012 bytes]

We could not dial-out or into the phone system. I am running Call Manager 4.02SR2. The gateway showed as registered in Call Manager and it would respond to a reset from the Call Manager but would not function. Has anyone seen this before??

Thanks,

Tony

tcekada@syseng.com

1 REPLY
Green

Re: Replaced 2811 voice gateway keeps downloading .cnf.xml file.

What is the status of D channel in GW?

show isdn status

Im assuming not CCM changes right (Switch type, Protocol side)

Havent find any DDTS related now,

sh ccm-manager shows any errors?

Looks sth in MGCP now its not doing its job.

Have you try recreating the GW in CCM and reconfigure MGCP in the GW...?

I recommend you to continue working with TAC in this matter.

HTH

//G

126
Views
0
Helpful
1
Replies