Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Replacing a VG248

Has anyone had any experience swapping out a VG248? We have a VG248 that needs to be replaced. When the replacement arrives, can we simply change the MAC at the Gateway config screen (and the unique MACs on the ports will follow) .... or do we have to build the VG and each port from scratch? Thanks for any help you can provide.

1 REPLY
New Member

Re: Replacing a VG248

Prior to 3.3 you will need to rebuild each port from scratch... I had experienced this when on 3.2 (bummer I know). From what I am told on 3.3 each port is built as a separate phone and you can just change the mac which is how it should have been all along... Can anyone else verify this is true for 3.3 I have not had the need to change one since we upgraded but would like confirmation.

Thank you

109
Views
0
Helpful
1
Replies