Reset DC password (when you don't know what it is)
Just trying to get a CCM up and running with DC. It is a restored CCM which was using AD for it's directory. We are now trying to revert back to DC for a test environment. However, following all the documents it has not worked.
Is there a way to reset the passwords (I know there is a tool if you know what the password currently is)? Or even blowing away the current DC directory and reinstalling it?
Re: Reset DC password (when you don't know what it is)
If I remember DC uses the local administrator account. You can reset that in computer management. Then log into the DC directory. Username would be Directory Manager and then the password. If that doesn't work let me know and we can change it in regedit.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...