What you can do is use cor-lists. The way cor lists work is that, you can define which inbound dial peers are allowed to use which outbound dial peers. Each list has a subset of groups and based on those groups you can give certain lists permissions etc. It is kind of complicated but thats the only way I can think of to do it. The way you would match an inbound dial peer, would be to use the answer address under the dial peer to match the ani and apply the restrictive cor list under there.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...