Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Restricting Codecs using MGCP

Is there a way to restrict the type of codecs that a 2524 will send in a call setup message to a media gateway controller using MGCP.

Currently it is sending 7 options. All that I want it to send back is just G711 and G729r8.

I looked at the mgcp codec command but that is setting the default codec and not setting the available codecs.

2 REPLIES
Anonymous
N/A

Re: Restricting Codecs using MGCP

Ment to say 2421 router and not a 2524

Anonymous
N/A

Re: Restricting Codecs using MGCP

all IOS gateways (incl 2421) send entire list of codec to the CA if the local conn options does not specify a codec. You cannot restrict this via command line

139
Views
0
Helpful
2
Replies