Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Ring List unavailable!

I get this message when I try to select another ring on IP Phone 7940. I get the selection between only the two hard coded chip ring tones.

It’s an intermittent issue.

I already check several things:

- TFTP started (I’ve restarted it)

- IP Phone restarted

- Enterprise parameter -> TFTP service -> File config cahed =False (in place of true)

- Ringlist.xml is OK (Because it’s working intermittently)

Also, between my IP Phone and CCM 3.3 SR4, there is a firewall PIX version 6.3(3). I solve the issue when I remove the command “no fixup protocol tftp” in firewall. But since then, I had problem to boot my IP Phones. Some were unable to boot because they were looking for their config file via TFTP. Then I had to put again the command “fixup protocol tftp”

Do you have more idea? Or workaround ?

4 REPLIES
Anonymous
N/A

Re: Ring List unavailable!

Which is the Phone Load you are using? This has something to do with the phone Load.See this bug:CSCec78298 Also, try using some other phone load and see if it works.

New Member

Re: Ring List unavailable!

Thanks so much. I upgrade the IP Phone Firmware with P00306000100 and there is no issue anymore !

New Member

Re: Ring List unavailable!

Where can i find the procedure to make the IP Phone Upgrade?

I want to upgrade 1 ip Phone specifically.

Silver

Re: Ring List unavailable!

If you want to upgrade just one phone put the new load id in the phone configuration > phone load name and reboot the phone. Also make sure you put the new load in the TFTPPath folder

401
Views
0
Helpful
4
Replies