I have CCM 3.2(2C) with SPF.When ever I try to change the ringer type it says ringer busy .The call manager was upgraded from 3.1(3a) to 3.2(2C).I did nto have this problem in the previous version of CCM.
I have had this in the past. When you experience the ringer busy, I found that if you then call the set from another phone it will release the Ringer State and let you then change the ringer type on the set. Good Luck.
It's a problem with the basic phone load in 3.2(2c), P00303020204. The bug-id is CSCdx82106. Upgrade to the 3.2(5) release of phone loads for 7940/7960 on CallManager 3.2. This will update your phone loads to P00303020214. You can get it here:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...