A department in our location wants to be setup so that if a caller calls ( user 1 ), the user doesnt answer, then on the 4th ring or so, the call would get pushed out so that everyones phone in that department will ring. Is this possible?
The ring-all hunt group functionality is not currently available in CallManager. It is promised for CCM v4 due out by the end of the year. There are currently 3rd party apps which can do this or you can use pick-up groups or the RNA forwarding to bounce the call around.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...