Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

RIP V1 and RIP V2 networks advertisment

I have got R1 and R2 connected through serial cable (S0/0----S0/0),,,,both routers are running RIP version 1.

R2 has got these networks 10.10.10.1/27 ,,,,134.10.14.5/28,,,,,,192.75.1.2/22.

IP address for R1 S0/0 is 134.10.10.2/24,,,,,,,, IP address for R2 S0/0 is 134.10.10.2/24

Both routers are configured to advertise all of their networks via RIP.

1- Now with RIP V1 all of them will be advertised as classfull (10.0.0.0/8 ,,,,134.10.0.0/16,,,,,,192.75.1.0/24).

2- With RIP V2 (same scenario as above but with RIP V2 on both routers) all of them will be advertised as classfull as well

3- With RIP V2,will these networks be advertised as classless (not classfull) if I enable no auto-summary ?

1 REPLY
Bronze

Re: RIP V1 and RIP V2 networks advertisment

Yes, your are right. no auto summary is used to reduce the number of entry in the routing table.

80
Views
0
Helpful
1
Replies
CreatePlease to create content