Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

route patterns under 3.1 3a

have route patterns changed under this release 3.1 3a the reason is I ahve 2 clusters with different version of Cm cluster 1 is running 3.1 and cluster 2 is running 3.1 3a

They have the same route patterns setup.

The problem is I Have a route pattern of 0.0011! and 0.0011!# on CM 3.1.You can match the pattern with the hash to stop the inderdigit time out and coonect the call straight away though under the 3.1 3a release this does dont work its one pattern or the other.

  • Other Collaboration Voice and Video Subjects
1 REPLY

Re: route patterns under 3.1 3a

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

101
Views
0
Helpful
1
Replies