We currently have a brand new router at our office that will be used in conjunction with CallManager 4.1 to provide basic IP telephony services. We just received a PRI connection from the phone company as well. I'm looking for a configuration example to configure the router based on MGCP. The router sho ver is as follows:
Cisco 3825 (revision 1.0) with 224256K/37888K bytes of memory.
Processor board ID xxxxxxxxxxx
1 FastEthernet interface
2 Gigabit Ethernet interfaces
2 Channelized T1/PRI ports
8 Voice FXS interfaces
Is there a link that can walk me though a basic configuration of the router.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...