Greetings.I am Yeoh here I just configured DID direct inward dial on the fxs port.RJ11 connection to pbx. dunno wheter it will function or not. should i configure the ring and voltage for the connection to run? Here i have router 2800 . Not really sure what is require to configure but the manager here says we need this running with pbx and only simple flat network. no other routing function used. the important part here is the voip configuration. I have two router one with fxs card another one with fxo. For what i understand is PBX connection plug to fx0 then from router a to router b using fe0/0 to fe 0/0 then from router b i connect it to the phone using FXS/DID is this correct? what is the configs to make my phone running. i plug it in but it seems not responding. no sound at all. just some small "TUK TUK TUK" voice in it.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...