I have a situation at hand that is quite confusing to me. The following is the case.
What's happening is that the phone attachect to PABX1 initiates a call to a phone attached to PABX2. When the call goes out the phone at 2 rings, but when it's picked up, the line is dead. I have tried some stuff with codec's but so far no speach over the connection.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.