Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Router Timng and synchronization for tdm Voip interfaces

What are the rules for timing 3600 Network modules and wics ? For example : can timing be derived from one wic and sourced to all TDM interfaces on the 3600 (or only the wic located on the same network module )? Can a serial interface or ATM OC3 network module timing be used to source timing to T1 / E1 modules.

1 REPLY

Re: Router Timng and synchronization for tdm Voip interfaces

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

107
Views
0
Helpful
1
Replies