Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ROUTING OF CALLS.

Hi,

We are having a requiremet as follows.

1. There are two voice gateways.

2. We do have E1 PRI installed in the voice gateway.

3. The customer is asking to use the first 10 channels of gateway A for incoming and remaining 20 channels of gateway B for outgoing.

4. The same requirement is for Gateway B. First 10 channels for incoming and remaining 20 channels for outgoing.

In case of outbound calls where do we configure to use only the last 20 channels in a gateway. once this is full the gateway B last 20 channels should come in to picture.

In case of incoming the first 10 channels in gateway A is full the call should come via the first 10 channels of gateway B.

How do we implement the above scenario in a CCM setup with two voice gateways.

Regards

Krishna.

1 REPLY
Silver
99
Views
0
Helpful
1
Replies