Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Routing to host device

We have two 2500s running HSRP from the ISP connected through a hub to a PIX firewall. We are looking at adding a second firewall. Given we will need to use addresses from the public ip range given by the ISP for our web servers, how can we route packets destined to these servers to the second firewall? Is there a way to route to a host device and not a network?

1 REPLY
New Member

Re: Routing to host device

Hi Jim, I think what you need is policy-based routing. This will alow you to direct traffic destined for the webservers to the firewall. Check it out on CCO : http://www.cisco.com/warp/public/105/36.html

Cheers, Marcel

135
Views
0
Helpful
1
Replies