Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

sample config for ICS7750 w/PRI, and DID's

I have an ICS 7750 setup with POTS lines coming in. We are switching to a PRI with DID's supported. Does anybody have a sample config of how to do this? I would greatly appreciate it. I have looked through CIsco's site, but I was unable to find a sample config. Thanks in advance for the help.

Jpoulos

1 REPLY
New Member

Re: sample config for ICS7750 w/PRI, and DID's

I am assuming that you mean that you now have an MRP in the 7750 that has pots lines terminated on it and that you are switching to an MRP with a T1 interface. this config will be very similar to configuring most routers to act as h.323 or mgcp gateways even though it is an mrp.

good links

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094636.shtml

http://www.cisco.com/en/US/products/hw/voiceapp/ps967/products_installation_and_configuration_guide_chapter09186a00800cdf82.html#xtocid25

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080a66.html#xtocid28

85
Views
0
Helpful
1
Replies