sample config for ICS7750 w/PRI, and DID's

[jpoulos]

I have an ICS 7750 setup with POTS lines coming in. We are switching to a PRI with DID's supported. Does anybody have a sample config of how to do this? I would greatly appreciate it. I have looked through CIsco's site, but I was unable to find a sample config. Thanks in advance for the help.

Jpoulos

[jmessina]

I am assuming that you mean that you now have an MRP in the 7750 that has pots lines terminated on it and that you are switching to an MRP with a T1 interface. this config will be very similar to configuring most routers to act as h.323 or mgcp gateways even though it is an mrp.

good links

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094636.shtml

http://www.cisco.com/en/US/products/hw/voiceapp/ps967/products_installation_and_configuration_guide_chapter09186a00800cdf82.html#xtocid25

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080a66.html#xtocid28