Re: Sample configuration on voice over frame relay and ipx
In case of Voice Over Frame-relay (VoFR) and IP/IPX on your PVCs, then you have layer2 packets which are sent in a different queue (dual-fifo queueing for vofr cisco is used) than layer 3 packets (IP and IPX). VoFR traffic takes the needed bandwidth when present and data uses the bandwidth when voice is absent in the network.
The sample config is below for one router; voice config on 3810 should not have an impact on normal data routing unless they are blocked by access-lists.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...