Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
610
Views
0
Helpful
1
Replies

SCCP behind NAT

cc2000
Level 1
Level 1

‎07-09-2002 08:48 AM - edited ‎03-12-2019 07:50 PM

On the subject of using a Cisco 7960 IP phone behind NAT:

1.

Does anyone know if there are any NAT implementations that support SCCP markup, aside from Cisco's IOS / PIX routers?

2.

Does anyone know what the aspects are of SCCP that cause it to not be supported by typical NAT implementations?

3.

Does anyone know of workarounds to allow typical NAT implementations to support SCCP markup?

Labels:
0 Helpful
1 Reply 1

mimckee
Level 1
Level 1

‎07-10-2002 06:32 AM

To answer no. 1 I don't know the answer. For no.2 the reason is the Source and destination addresses are also in the payload as well as the ip header. The normal nat process only rewrites the address in the header not in the payload. For no.3 the only thing that comes to mind is a tunnel or something where you are not doing NAT at all.

Thank you,

-Mckee

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents