Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

SCCP gateways for voice instead of MGCP on 2811 ??

Hello,

I have CM 5.0 installed, and am using a 2811, with BRI to act as a PSTN gateway, using MGCP controlled backhaul of BRI signalling.

However, I also see the option in CM5, to use SCCP for gateway configuration.

Can SCCP be used on a 2811 for PSTN access ? The docs seem to suggest only 3 gateway models that support SCCP, but the options is available in CM.

I was under the impression that SCCP could only be used for transcoder / mtp config on a voice enabled router.

Can SCCP also support PSTN protocols in a gateway mode to CM 5??

2 REPLIES
Silver

Re: SCCP gateways for voice instead of MGCP on 2811 ??

Yes, you can use SCCP on a 2811 for PSTN access.

Community Member

Re: SCCP gateways for voice instead of MGCP on 2811 ??

Thanks, but can you point me to any docs , weblinks etc that can give me some more info ?

I have searched the cisco website, but cant seem to find out how to configure this, or any further info on doing this using a 2811.

162
Views
0
Helpful
2
Replies
CreatePlease to create content