I want to deploy around 100 IP Phones for Home users,
All of them have ADSL Connectivity and ADSL modem with One IP Address,
The modem itself handles the NAT and gives 10 non routable IP,s to client in the LAN
The home user don?t have any Cisco router so I canned use NAT translation on SCCP in Cisco IOS command
Is it possible to install IP PHONE or ( Cisco IP Communicator ) for them?? I know we can use VPN and have a tunnel to our central office but This is not a goos solution in my Case because I want to deploy this for end user and they don?t want to have a VPN connection only for their phones
These ADSL modems are from different factors and none of them are Cisco,
So can any one help me to get rid of this NAT issue forever?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...