When I click on the link in my previous post, I get a list of SCCP phone loads. Some of the files are zips such as cmterm-7911-sccp.7-2-1.zip. These zip files contain only the firmware files for the given phone type.
Thanks for the reply once again Brandon. But I'm still getting the following message "NOTE:
There are currently no files for this type." when i click on the link. When you login do you have special access rights, that could be the problem, i might have less rights than you.
Would it be possible for you to send me the zip file by email? The phones are 7912 and the bmp2logo.exe file etc. are what i am looking for. If you can send it via email, this is my email address : firstname.lastname@example.org
Hey Brandon .. that link worked fine for me, so I'm not sure what the problem is. There were two places that required a valid CCO password,once to access the page and once for the actual FTP download.Thanks, as always !!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...