Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Second NIC on Call Manager 7.01

Hello,

Is there any possibility to use the second nic o CUCM 7.01 in a different network?

Is it just unsupported or really impossible to configure?

thanks,

met.

3 REPLIES

Re: Second NIC on Call Manager 7.01

As far as I am aware it is impossible to set separate IP addresses for NIC1 and NIC2 in any LINUX based CUCM release.

You can set the NICs for active/standby but that is all.

Out of interest why do you need to put the second NIC in a different network?

New Member

Re: Second NIC on Call Manager 7.01

Hello jamesha, thanks for your thoughts, i already realized that!

Well why? Good practice to have one service interface and one management interface.

Thanks!

Re: Second NIC on Call Manager 7.01

I am not sure if it's good practice for servers though..

If you would have 2 nic's with seperate subnets, you can easily introduce faults by i.e. configuring incorrect routes etc.

We use iLo however, which is on a seperate subnet, and with advanced license you can even connect to the CLI interface. (only when things turned to custard ;-) )

373
Views
0
Helpful
3
Replies