Scenario: Two Callmanager 4.1x clusters connected via intercluster trunk. Four digit dialplan across cluster. Site A (x1000, external phone number mask 201-111-1111) dials site B (x2000, external phone number mask 201-222-2222). Site B's phone is forwarded out to a cell phone.
Goal: when Site A dials Site B I want Site A's 4-digit extension to appear on Site B's display. If the call is forwarded out to the PSTN, I want Site A's external phone number mask to display.
This can be done on a one-to-one cell phone number basis. Temporary fix.
On Site B, Create a CTI route point or CTI port, with call forward all to the required cell phone number. Set the CTI ports External phone number mask to Site A's phone number mask.
CFWd all from Site B's phone to the CTI route point's number. (Note the two levels of forwarding)
When phone at Site A calls phone at Site B, it forwards the call to CTI route point, and from there to the cell phone. The number that shows up will be the external phone number mask configured on the route point which is site A's mask. This will work provide you dont over ride external phone number mask at Site B at the route-list, route pattern level.
You certainly get high marks for creativity, though this is impractical for my needs. The bigger picture includes having phones from one site route out PRIs from other sites in the event of an outage. This is easy to do, though specifying internal vs external masks to apply is the trick. Thanks for the effort.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...