The outbound side is controlled by CallManager, so simply include the Gateway you want to use for outbound calls in the route group, do not include the one for inbound calls. The inbound side is little trickier because that is controlled by the service provider, in most cases when you have multiple PRIs they are assigned to the sam,e Trunk Group so they can deliver calls to the same destination on either E1/T1. Contact your telco service provider and let them know that you do not want to receive inbound calls on this E1.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...