I have a 7847 server. What is the general consensus on the maximum number of accounts this box will support if running both exchange and unity? At one point I thought it was 200 user accounts and wondering if this is still correct, with the beefed up hardware of the 7847.
Expansion chassis supported for additional voice boards
Up to 2500 users for Unified Messaging (message store off the Cisco Unity server)
Up to 2200 users for Voice Messagingrecommended
Up to 150 VMI users
Up to 150 CPCA users
Up to 12 TTS sessionsCisco Unity 3.1x
Up to 24 TTS sessionsCisco Unity 4.0
Dual Pentium III 1.26 GHz processor
1.0 GB RAM
5 hard drive configuration:
RAID1 (2 x 18 GB, Ultra3, 10K RPM hard drives)
RAID5 (3 x 36 GB, Ultra3, 10K RPM hard drives)
Redundant power supply
USB for Cisco Unity 3.x
None required for Cisco Unity 4.0 and later
Tape drive is available as an option
SMARTnet services available
Approximate message storage (in minutes)*
G-71167,270 (1,121 hours)
G-729538,160 (8,969 hours)
*Assumes half of addressable drive space reserved for recovery, Exchange 2000 (Voicemail Runtime) Enterprise Edition. This is for Voice Messaging deployments with local message store only. In Unified Messaging deployments the amount of storage time available for messages depends upon the Exchange or Lotus Domino network storage capacity
Understood. I guess my question goes to what if the message store is on the box. For example, I have a small campus environment w/ approxiametely 200 users that will need UM and another 300-400 that will need only VM. Will this box adaquately(sp?)support this in the short-term until the budget allows for a dedicated Exchange Box? If so what would be the maximum recommended number of UM and VM users?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...