I have changed the service parameter for Always Use Prime Line to True so that the phone will not answer the second DN automatically if it is ringing, however it does not allow this to happen. I also have the phone set to disable auto line select. I am running CM 4.1.3 and 7941,61,70 phones. Does anyone have any ideas?
Have you changed the value for all subscribers in the cluster or just on the publisher? All CCMs that perform call processing may need to be selected from the service parameter drop-down and changed, saved.
I have had the issue where a clusterwide parameter was not carried over to all subs untill a complete reboot was performed - once changed on all in the services page it worked for 4.1(3)sr3c.
Yes, I have checked the parameter on both servers. We have a publisher and a subscriber. I have also rebooted both servers this morning and still have the same issue. I'm running sr3b, maybe I should try to get the sr3c update.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.