Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Services disabled on CM3.3 install

After a clean install on a 7825 of 3.3(2), single CM publisher system. It tells us the upgrade has completed and to restart, but once we do , the services all come up as "disabled".

Making the services "automatic" and restarting the server, causes them all to hang when starting.

VERY bizarre - any ideas?

3 REPLIES
New Member

Re: Services disabled on CM3.3 install

All sorted now thank you - found my mistake - Doh!

New Member

Re: Services disabled on CM3.3 install

I have the same problem, can you tell me what was your solution?

Thanks,

Attila

New Member

Re: Services disabled on CM3.3 install

By default the CCM 3.3(2) disables all of the services and you need to go into:

Start->Programs->CCM 3.3->Cisco Service Configuration

You then activate the services per server that you want to run.

86
Views
5
Helpful
3
Replies