Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Setup for Group in CallManager 5.0.4

I am trying to setup a group so that when someone calls into my phone system and it is answered by Unity, users would dial 6 and it will call a hunt list which is 600 to ring through a couple of phones for Technical Support.

5 REPLIES
Silver

Re: Setup for Group in CallManager 5.0.4

Hi,

Are you familier with call handlers and caller input?

Basically, you can create a caller input on this subscriber account (for keypad 6) which forwards onto a call handler.

Then you could configure the handler to forward out to the hunt pilot configured in CallManager?

Caller input configuration:

http://www.cisco.com/en/US/docs/voice_ip_comm/unity/403/administration/guide/ex/SAG_0170.html#wp1149904

Call Handler configuration:

http://www.cisco.com/en/US/docs/voice_ip_comm/unity/403/administration/guide/ex/SAG_0200.html

Please rate useful posts...

New Member

Re: Setup for Group in CallManager 5.0.4

So I created my hunt pilot. Internally I can call the extension, 600, that I setup for the gruop and it will ring through all the phones in the group. When I try to create the handler, I cannot get it to forward properly.

Cisco Employee

Re: Setup for Group in CallManager 5.0.4

configure caller input to attempt transfer to X handler, on the handler itself configure the transfer options to "yes, ring subscriber at this extension"

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Silver

Re: Setup for Group in CallManager 5.0.4

Yep, as per Java's last comment, this should do it! 5*

..let us know if you have any more problems.

New Member

Re: Setup for Group in CallManager 5.0.4

Ok, I setup to the call handler to ring the subscriber's extension but it does not seem to be transferring from Unity to CallManager. I have set this up previously for the Operator to a group and it works. I am just confused. Maybe I will start from the beginning and rebuild it.

119
Views
5
Helpful
5
Replies