Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

sh isdn active

I'm running 12.2(19) on a 5300.

when I have active calls, 'sh isdn service' works but 'show isdn active' isn't working properly. Some calls appear, others don't. See below, two calls are active but only one appears in sh isdn active. Any ideas?

PRI Channel Statistics:

ISDN Se0:15, Channel [1-31]

Configured Isdn Interface (dsl) 0

Channel State (0=Idle 1=Proposed 2=Busy 3=Reserved 4=Restart 5=Maint_Pend)

Channel : 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1

State : 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 3 2 0 0 0 0 0 0 0 0 0 0 0 0 0 2

Service State (0=Inservice 1=Maint 2=Outofservice)

Channel : 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1

State : 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 2 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0

worldcomgw001#sh isdn a

--------------------------------------------------------------------------------

ISDN ACTIVE CALLS

--------------------------------------------------------------------------------

Call Calling Called Remote Seconds Seconds Seconds Charges

Type Number Number Name Used Left Idle Units/Currency

--------------------------------------------------------------------------------

In ---N/A--- 8117 8 Unavail -

--------------------------------------------------------------------------------

1 REPLY
Silver

Re: sh isdn active

This is a bug in the IOS. Check the bug - CSCin51625.

100
Views
0
Helpful
1
Replies
CreatePlease login to create content