Here is a list for the hardware running 12.1(3)T T1 and E1 PRI Q.931 user side and network side (NET5) T1 and E1 CAS T1 and E1 PRI QSIG E1 MelCAS E1 R2 CAS T1 and E1 Transparent CCS (with Multi-D channel) E&M (wink, immediate, delay), FXO/FXS loop-start and ground-start signaling Inbound signaling (such as DTMF, MF support) If your PBX can support any of the signalling type above, the go to this page and configure your E1/T1 interface to communicate with it using the same signalling suppported. http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t7/t1_vo_t6.htm
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4