Here is a list for the hardware running 12.1(3)T T1 and E1 PRI Q.931 user side and network side (NET5) T1 and E1 CAS T1 and E1 PRI QSIG E1 MelCAS E1 R2 CAS T1 and E1 Transparent CCS (with Multi-D channel) E&M (wink, immediate, delay), FXO/FXS loop-start and ground-start signaling Inbound signaling (such as DTMF, MF support) If your PBX can support any of the signalling type above, the go to this page and configure your E1/T1 interface to communicate with it using the same signalling suppported. http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t7/t1_vo_t6.htm
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...