I have a scenario where my phone system connects to a channel bank and then to a T1 (our service provider). The problem occurs when I try to run the T1 (service provider) into the AS5350 T1 controller 3/1 and connect 3/0 to the channel bank. This forces every phone in my office to go bonkers. I'm not sure why this occurs, but assume it has to do with a signaling mismatch. But I've not been able to prove or disprove that. The Channel bank configuration shows Inbounf and out bound signaling as: Loop-ground Wink start. How can I set this on the cisco? Or should the cisco be passive for signaling as the network is fine when the cisco is removed. Thanks.
Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.