Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Simple h323 with CCM question

I am attempting to set up the following:

I have a POTS line plugged into FXO port 0/1/3.

I want that POTS line to ring extension 89047 on CCM.

I know this is simple, but I must be missing something. Here is what I have on config:

dial-peer voice 33 pots

description Line_3

direct-inward dial

progress_ind setup enable 3

progress_ind alert enable 8

forward digits all

port 0/1/3

dial-peer voice 999992 voip

preference 1

destination-pattern 890..

progress_ind setup enable 3

session target ipv4:10.10.1.50 (CCM ADDRESS)

incoming called-number .

dtmf-relay h245-alphanumeric

codec g711ulaw

ip qos dscp cs5 media

no vad

7 REPLIES
Silver

Re: Simple h323 with CCM question

you need: connection plar 89047 on the voice port.

HTH Pls rate!

Community Member

Re: Simple h323 with CCM question

Sorry I did not include that in original. I do have the PLAR statement. I can do a debug on the dialpeer, and it is hitting the proper dialpeer and trying to dial 89047, but I get fast busy. 89047 is a Hunt Pilot in CCM.

Thanks

Silver

Re: Simple h323 with CCM question

Can you dial the hunt pilot internally? Does it work?

Community Member

Re: Simple h323 with CCM question

Yes, from an FXS port regisered MGCP it is possible to dial the hunt pilot.

Silver

Re: Simple h323 with CCM question

did you try connection plar opx?

Community Member

Re: Simple h323 with CCM question

No luck with OPX statement. It will ring, but no answer when using OPX.

Thansk

Silver

Re: Simple h323 with CCM question

Can you port more of the router config? Is the hunt pilot in a partition?

123
Views
0
Helpful
7
Replies
CreatePlease to create content