Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Simple voice trunking with Catalyst 6500 & WS-X6608-T1 module w/o Call Mgr

Is it possible to provide simple T1 voice trunking between two Definity PBX's using the WS-X6608-T1 module, one per Cat 6500 with the 6500's connected via Gigabit ethernet without using Call manager or any other components other than the 6500's and the WS-X6608-T1 modules?

2 REPLIES
New Member

Re: Simple voice trunking with Catalyst 6500 & WS-X6608-T1 modul

3gcasper,

I haven't checked the specific module you mentioned. I'm assuming this card has the DSP chips to do VoIP analog to digital conversion. But many companies use a setup like this to do "toll bypass". Calls forwarded from the PBX are digitized into VoIP data packets and sent (across the data network) to other VoIP devices according to the dial plan. The receiving VoIP device converts the call back to analog and sends it on the voice trunk to the local BPX.

Regards,

Rob Bristow

AT&T Solutions

CCIE #3335

New Member

Re: Simple voice trunking with Catalyst 6500 & WS-X6608-T1 modul

As far as i know you need to have Call Manager to use the Ws-X6608 blade. Unlike a router or the AGM module the 6500 T1 blade does not have an IOS that you configure and i do not know of any way to put an IOS on them.

226
Views
0
Helpful
2
Replies
CreatePlease login to create content