Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Simultaneous calls on MC-3810

Hello,

Does anybody know how many simultaneous calls is supported by a Cisco MC-3810 with good voice quality? It is connected to a PBX trought an E1 interface, I´m using voice over frame relay with G.729 compression. Thank you!

Here are some characteristics:

System image file is "flash:mc3810-is-mz.120-2a.T1"

Cisco MC3810 (MPC860) processor (revision 16.00) with 27648K/5120K bytes of memory.

Processor board ID 14763183

PPC860 PowerQUICC, partnum 0x0000, version 01(0x0031)

Channelized E1, Version 1.0.

Bridging software.

X.25 software, Version 3.0.0.

Primary Rate ISDN software, Version 1.1.

MC3810 SCB board (v16.A0)

1 6-DSP(slot2) Voice Compression Module(v02.A0)

1 Ethernet/IEEE 802.3 interface(s)

2 Low-speed serial(sync/async) network interface(s)

1 Channelized E1/PRI port(s)

256K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (AMD29F016)

1 REPLY
Bronze

Re: Simultaneous calls on MC-3810

This says 15 simultaneous sessions: http://www.cisco.com/warp/public/cc/pd/iosw/ioft/mmcm/prodlit/mmcm_fs.htm (depending on bandwidth and other factors).

89
Views
0
Helpful
1
Replies