Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SIP & H323 AS5300 Configuration

Does any one have a sample configuration of an AS5300 terminating SIP and H323 calls on the same box???? Or how can I do it??

Thanks in advance!!

1 REPLY
Community Member

Re: SIP & H323 AS5300 Configuration

In case that the gateway been used for termination only you really don't need to do anything.

By having proper IOS that supports both protocols you pretty much covered.

Base on the call session (Either SIPv2 or H.323) the AS5300 CCAPI will synch it self according.

You just need to setup POTS dial peer to capture the calls and direct them to the T1/E1 lines.

165
Views
0
Helpful
1
Replies
CreatePlease to create content