Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SIP - How close active call, if destination goes down

Hi,

I use “connection trunk 26“ syntax on voice port and number 26 match with VoIP dial-peer. VoIP dial-peer uses UDP SIP as transport protocol.

All works fine, but my problem is that if destination device goes down, call (trunk) is still active and RTP is sending.

It’s possible check state of destination device and close active call if destination device is down?

voice service pots

fax rate disable

!

voice service voip

fax protocol pass-through g711alaw

h323

modem passthrough nse codec g711alaw

sip

!

voice-port 0/0/1

operation 4-wire

type 5

signal immediate

compand-type a-law

connection trunk 26

!

dial-peer voice 100

destination-pattern 26$

session target ipv4:10.10.10.11

session protocol sipv2

fax rate disabled

codec g711alaw

no vad

!

sip-ua

!

Thanks

Jaroslav

  • Other Collaboration Voice and Video Subjects
Everyone's tags (2)
3 REPLIES
Hall of Fame Super Gold

SIP - How close active call, if destination goes down

clear call voice.

New Member

SIP - How close active call, if destination goes down

Hi Paolo,

Thank you for your response, but I’m looking for automatic “connection tracker”. I need some SIP/ICMP keepalive and disconnect all calls in situation, when a destination device doesn’t response.

Hall of Fame Super Gold

SIP - How close active call, if destination goes down

You can use RTP/RTCP media inactivity detection, session timeout, or options-ping. All are described in documentation.

1364
Views
0
Helpful
3
Replies