I've created a SIP trunk between two SIP Proxy servers (Linksys SPA9000) and can successfully call between the two systems but the caller displays as the proxy server instead of the phone, this makes sense as the proxy server uses it's own subscriber information when establishing a call. Does any know if it's possible to get a SIP proxy server to "pass-through" the callers information?
I had the same thing when linking the Linksys to a CCME system
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...