I have enabled a sip trunk between sipproxy and ccm ,the sip phone and sccp phone can call each other.But I have no idea with the two issues as below.
1. I want to use the sip phone to dial the external PSTN number via the MGCP gateway registered in ccm.In the ccm environment,I configure the route pattern as "9.xxxxxxxx",I can call the local PSTN number via the gateway (use sccp phone) .But how can I configure the sipproxy / sip trunk /ccm route pattern to match my requirement?
2.I have two subscribers in the ccm cluster, need I configure two static routes to the two subscriber separately so that the sip phone can call all the phones in the ccm environment ? Does my proxy (version 126.96.36.199) support it ?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...