I'm having a problem with a 7960 sip phone registering with CME 3.4. The phone works fine with CSPS. when it tried to register with CME 3.4, from debugging logs (debug tftp event, debug voice register event, debug voice register error), it shows it's looking for sccp images like P003 instead of P0S3. so the phone keeps resetting to get the right configuration files.
why it was looking for sccp images and configurations?
You can provision both SIP and SCCP phones on your Cisco CME router by using the same software command-line interface (CLI). New and modified commands for configuring SIP phones are similar but not identical to the commands for configuring support for SCCP phones. To support phone provisioning for SIP phones, a subset of the voice register pool configuration mode is modified to accept per-phone configuration parameters. Commands under the following configuration modes are used to configure Cisco SIP IP phones on your Cisco CME router:
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.