11-21-2017 11:14 PM - edited 03-13-2019 10:05 PM
Hi,
we have two CUCM 9.1 & 11.0, need to communicate both CUCM End-users.
FYI. We were configured SIP TRUNK and router pattern, but no communication.
Solved! Go to Solution.
11-29-2017 12:31 AM
We were configured ICT, and it's working fine.
11-22-2017 07:16 AM
What troubleshooting steps have you taken?
Can you PING the sub of one cluster from the SUB of the cluster ?
After configuring the trunk did you make sure to save, apply config , reset?
What is the status of the trunk , top part of the trunk screen?
11-22-2017 09:45 AM
11-22-2017 07:46 AM
"no communication" doesn't provide any detail of what is not working to provide any assistance
signaling?
RTP?
call ring and drop?
11-22-2017 10:05 AM
11-22-2017 10:38 AM
Any FW's in between the two clusters?
A DNA run from each cluster going to a number on the other shows the call getting out correctly?
11-22-2017 11:10 AM
11-29-2017 12:31 AM
We were configured ICT, and it's working fine.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: