Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SkinnyGetCallState DN error -1

ephone 1(ext3519) calls on ephone 2(ext3525), upon successful connection ephone 1 puts ephone 2 on Hold.

After it: debug ephone error mac-address 0012.7f0f.3f8d, where mac-address belongs to ephone 1

gives the following:

...

7w0d: SkinnyGetCallState DN error -1

7w0d: SkinnyGetCallState DN error -1

7w0d: SkinnyGetCallState DN error -1

...

The appearance of the following line debug corresponds to signal “beep” of ephone 2

debug detail ephone 1 attached.

In spite of this error, the calls inner CME function normally, the problems begin in case the calls are made through dial-peer:

dial-peer voice 1000 voip

destination-pattern 0...

translate-outgoing called 1000

session target ipv4:192.168.5.254

dtmf-relay h245-alphanumeric

codec g711ulaw

ip qos dscp cs5 media

no vad

Upon pushing on hold by the talk through dial-peer voice 1000 it comes one-side audibility, the subscriber inner CME can hear, but inner dial-peer the subscriber CME does not.

How this error can be eliminated?

Thanks.

1 REPLY
Silver

Re: SkinnyGetCallState DN error -1

Can you try configuring: transfer-pattern .T If you are using Firewall, problem could be in firewall.

106
Views
0
Helpful
1
Replies
CreatePlease to create content