When I press the Redial button on my IP Phone 7960 to redial an outside number, it takes a second or two for the IP Phone to display the number and start redialing. Some of my users told me sometimes it takes about six seconds or more...but they tend to exaggerate...
When I do the same thing to redial an internal number, i.e. another IP Phone, the redial is always *immediate*.
Is there an easy way to fix this problem? Or are my users asking too much?
We are having the same problem. I believe it is an issue with the firmware load running on the phone. We are using CM3.1.2c and IP 7960 phones w/ firmware version 220.127.116.11 , boot load PC030300 and app load P00303010102.
Have you tried updating the phone loads and firmware? Maybe that will help out....
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...